Experienced a break with the peg of Eukrante's Bazooka/BFG

[GlennShiraishi]

I tried to make the combination for Eukrante's weapon but I did the shield part a bit too early and when I attached one of the wings I heard a snap and then I tried to de-attach the shield and the wing and the Peg was broken inside the shield..Is there a way for me to unstick it from the shield and glue it on the BFG to fix it?

[Klinkin]

Which peg in particular did you break, and which hole is it in? Let me see if I have this right: you were trying to create the Tempest launcher, and when attaching the flash guard/backplate to the top of the barrel, the peg that, in normal gun form, is on the top of the stock, broke off in one of the holes in the backplate? The backplate has two holes; one goes all the way through, the other doesn't. If the peg is stuck in the former hole, just push it out. If it's the latter hole, then you're not getting it out short of drilling it. Luckily, that second hole isn't really needed for anything. As far as replacing the peg goes, if you still have the sprue that the bitz came on, you can cut a short length of that and pin it to the gun to replace the old peg; they're not only the same diameter, but the sprue even has the little ridges, same as the pegs (something I'm sure was intentional on Konami's part).

[GlennShiraishi]

Which peg in particular did you break, and which hole is it in? Let me see if I have this right: you were trying to create the Tempest launcher, and when attaching the flash guard/backplate to the top of the barrel, the peg that, in normal gun form, is on the top of the stock, broke off in one of the holes in the backplate? The backplate has two holes; one goes all the way through, the other doesn't. If the peg is stuck in the former hole, just push it out. If it's the latter hole, then you're not getting it out short of drilling it. Luckily, that second hole isn't really needed for anything. As far as replacing the peg goes, if you still have the sprue that the bitz came on, you can cut a short length of that and pin it to the gun to replace the old peg; they're not only the same diameter, but the sprue even has the little ridges, same as the pegs (something I'm sure was intentional on Konami's part).

I think it was the peg on the barrel of the Tempest Launcher which I attached to the latter hole before attaching the wings as I have seen on the Manual..
I do have to mention that I managed to get the hole out with some luck and the break left a bit of a gash behind on the place where the peg broke with part of it being attached to the peg and glued it perfectly on.
for next time I'll just be careful when creating the Tempest Launcher and the Tension Mode form for the Armor